Technics SA-DX930 - Preparing for Surround Sound; Adjusting Speaker Output Level; Testing Speaker Output

RQT4918
DO HE HCM aa tne Th
: 7d: n 7
pass HUN LIL
= » a > 9 @ è ò 89 9 9 * 9 9» €* 5» 9 99 $9 * € * $ * $9 €* LU
L— C= R= RS~LS—SW
Se ed
a . * * .* e . e . a . `>. e # * b @ . . s s a à 9 o o uU
E:
* e ~» «© € 9 $$ © * ^ $$ $ 9 9 "un 9 * * © © * © @ wa l
LEVEL
KERS-
C — RS = LS — SW
[|
ese è e e è s s è . "ov . LJ € à u ó t $ * è 9 5» ^^ @
| Preparing for surround sound
E)
Do these steps to get the most from your home theater system.
Adjusting speaker output level
by remote control
Adjust Speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source,
Preparation
e Turn ON the speakers with [SPEAKERS A].
* Adjust front speaker balance with [BALANCE].
Press [SURROUND] to select “SURROUND”.
“SURROUND” appears on the display.
This procedure must be done in the SURROUND mode.
Press [TEST] to output the test signal.
“TEST” appears on the display.
The signal is output from each speaker in order for about two
seconds each:
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as "NONE" or "OFF" are skipped.
g
Press [VOL (- or +)] to set the volume level
normally used for enjoying the source.
>
Press [LEVEL] to select the speaker channel
to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as "NONE" or "OFF" are skipped.
Press [-] or [+] to adjust the level to the same
apparent level as the front speakers.
The four channels can be adjusted between -10 dB and +10
dB, with zero being the current level of the front speakers.
n Repeat 4 and 5 for each speaker channel.
To stop the test signal
Press [TEST].