Technics SA-DX930 - Subwoofer Channel Setting; Enabling;Disabling Subwoofer Output; Understanding Speaker Indicators

Preparatory steps
|
1
Subwoofer channel setting EJ |
Press [SUBWOOFER] to select "ON" or “OFF”. |
"SUB-WFR" appears on the display and the current setting, "ON" |
or “OFF,” is shown. Press again to switch between “ON” and
“OFF.” l |
ON: select if you are using a subwoofer.
OFF: select if you are not using a subwoofer.
Select "OFF" also when you don't want sound to come from the
` subwoofer because you are listening to stereo sources. |
1
For your reference: |
The settings remain as they are until changed by the above |
SUBWOOFER procedure, even after the power has been turned off. |
$3 | The speaker indicators E |
pee t | |
kes- QJ fet S 04 4 | This part of the display indicates which speakers sound is coming |
HL
d
dL
UYNI
FA
|
from.
i
! If "NONE" or "OFF" is selected during the speaker settings
| | procedure, the corresponding indicators do not light.
; The surround and center speaker indicators do not light when
IGRI |! STEREO mode is selected (™ page 24).
LHN |
|
AE
z
BERS | „©
|
[:
| | wt
| E
| DCN
|
f
Surround Surround
| speaker speaker
(left) : (right)
Subwoofer |
Front speaker Front speaker
(left) (right)
ROT4918