Technics SA-DX930 User Manual

RQT4918
FM indoor antenna
(included)
Adhesive tape
AM loop antenna
(included)
Screw (included)
Antenna connections
FM indoor antenna (included)
This antenna is normally sufficient for reception of FM broadcasts.
Attach to a wall (using tape) facing in the direction of best
.reception.
For best reception
An FM outdoor antenna is recommended.
AM loop antenna (included) E
This antenna is normally sufficient for reception of AM broadcasts.
Fit the AM loop antenna holder (included) onto the rear panel of
this unit and then attach the AM loop antenna to the AM loop
antenna holder (facing in the direction of best reception).
Pay attention to the following points when mounting the
antenna.
e Do not mount it close to power cords, speaker wires or metal
surfaces (doing so will result in noise).
* Do not mount it close to a tape deck. When the tape deck is
being used, chirping or beeping sounds may result.
When mounting the antenna to a column, a wall or rack f$
Mount the antenna so that the hinge is vertical.

Technics SA-DX930 Specifications

General

Impedance	8 ohms
Weight	11.5 kg
Video Connections	Composite video input/output
Power Output	100 watts per channel (8 ohms, 20 Hz - 20 kHz, 0.09% THD)
Total Harmonic Distortion	0.09%
Input Sensitivity	200mV
Tuning Range	FM, MW
Speaker Load Impedance	8 ohms
Input Sensitivity/Impedance	200 mV / 47k ohms (CD)