Technics SA-DX930

" * LJ ` + 2 so ¢ a + a . * . LJ * oe è 4
DSP
STEREO SURROUND DTS SFC
o o o o
E 4 cease a ana Th
HON EY LIL NL CH
(ERS-
1
i
EH HOCH a ina Th
HO EY LAL MT
|
(ERS-
IOE a HUI EL TI
HUY EN LH HEN FH
DSP
STEREO SURROUND OTS SFC
o o o 5°. MODE
(O)
| (Ti
LH
Selected mode
a
Do
PRO LOGIC
DODIGITAL
| Enjoying sound modes
Ki Turn [INPUT SELECTOR] to select the desired
source.
Start the desired source.
Turn the sound mode selector to select the
desired mode.
The selected reproduction mode appears on the display.
(=> Page 24-25 for descriptions of the mode.)
STEREO: STEREO
SURROUND: SURROUND
One of the following indicators lights to
indicate the source.
(à DOPRO LOGIC: Lights if the source is
' Dolby Surround format.
(6) ES: Lights if the source is DTS format.
© DODIGITAL: Lights if the source is Dolby
Digital Format.
DTS: DTS
SFC: HALL, CLUB, LIVE, THEATER or SIM SURR
Select the mode to suit the source’s format. Dolby Digital
and DTS, for example, cannot be played back in an SFC
mode. If either EXB or DO DIGITAL appear while using SFC,
use SURROUND instead.
(only if you select SFC in the above step)
Turn [MODE] to select the desired SFC mode.
For your reference
You can set the sound mode for each source.
Each source will retain the selected mode.
Ensure the front speakers are connected to the A terminals when
you use SURROUND, DTS and SFC modes. The SURROUND,
DTS and SFC modes cannot be turned on if "SPEAKERS BP" is
Selected.
Only Dolby Digital, DTS or PCM signals :: can be reproduced
through the digital terminal:
e The digital! input signal of sampling frequencies 96 kHz and
other signal formats such as MPEG cannot be reproduced on
this unit.
e When playback is started, the sound may be cut or interrupted
before the input source is confirmed as Dolby Digital or DTS.
x PCM signal: This refers to the recording format of signals
(44.1 kHz, linear 16 bits) used for audio CDs.
|
—————————————————————————————————————————————— —— —————————— ———————"'— PO"
Sound modes
D
RQT4918