Technics SL-G700

41
(Continued)
Programme playback
1 Press [NWP].
2 Press [PGM] in the stop mode.
• “Program Mode” screen is displayed.
3 Press the numeric buttons to select
tracks.
• Repeat this step to make further selections.
4 Press [ ] to start playback.
Stop
Press [
].
• Programmed contents are
stored.
Check the
programmed
order
Press [
] or [ ] in the stop
mode.
Add tracks Do step 3 in the stop mode.
Clear the last
track
Press [CLEAR] in the stop
mode.
• You cannot select and clear a
desired programmed track.
• Press [PGM] in the stop mode to cancel the
programme mode, and the programme memory
will be stored.
• To cancel the programme mode (The programme
memory will be cleared.)
Press [ ] in the stop mode.
Press [ ], [ ] to select “Yes” and then press
[OK].
Note
• The programme memory will be cleared in the
following conditions.
 When turning on/off this unit
 when replacing the CD
 when switching the layer
• The programme mode is cancelled when the
random playback is set.
• Programme playback is not available while this unit
is in “Pure Disc Playback” mode.