89
(Continued)
Playback does not start.
• Depending on your environment or connected
devices, it may take some time.
• Check to see if the format of the file is supported.
For supported formats, refer to “File format”.
(⇒ 107)
The unit turns to standby mode automatically.
• Is the auto off function turned on? (⇒ 76)
• This unit may turn to standby mode simultaneously
with the connected device with the system control
function. (⇒ 83)
The settings are reset to the factory defaults.
• Updating the firmware may reset the settings.
The system control function is not working.
• Use the system connection cable supplied with the
connected device.
• Connect the system connection cable to the
system terminals (CONTROL). (⇒ 82)
• Connect Technics device supporting system
control function (Stereo Integrated Amplifier,
etc.) to this unit. For details, refer to the following
website.
www.technics.com/support/
To Next Page
Loading...
Need help?
General
