97
Please Wait
This is displayed, for example, when this unit is
turned to standby/on. (For up to approx. 1 minute
and 30 seconds)
• Wait for the display disappears.
Reading
The unit is checking the CD information.
• After this display has disappeared, start operating.
“Remote
” (“ ” stands for a number.)
The remote control and this unit are using different
modes.
• Change the mode on the remote control. (⇒ 22)
Searching
The unit is checking the media server on the
network.
• Check to see if there is a server in same network.
Unlocked
“COAX” or “OPT” is selected, but no device is
connected.
The sampling frequency components, etc. of the
audio signals are not input correctly.
• Check the connection with the device. (⇒ 48)
• For supported formats, refer to “File format”.
(⇒ 107)
USB Over Current Error
USB device is drawing too much power.
• Disconnect the USB device and turn the unit to
standby and on again. (⇒ 45)
• Turn this unit off and on.
Wi-Fi Setup
Select “On” and press [OK] to enter the network
setting. (⇒ 30)
• To exit the network setting, select “Off” and press
[OK].
To Next Page
Loading...
