Troubleshooting Guide
assistance
Problem
Causes
Remedy
Disc compixtment does not open
*This is not a malfunction. This is a design
*When opening the disc compartment,
when the open button is pressed
feature which protects the disc.
press the stop button to stop disc rotation, and
during play or in the pause mode.
the” press theope” button.
Disc is insened but “umber of
*The lock shaft is in the out position (1). *Pressto the in (unlocked) position (X-4
tracks and playing time are not
*Disc is inserted upside down.
*Insert disc again properly.
displayed.
*Disc is dirty. *Wipeclean with soft cloth.
*Disc is scratched. *Use a new disc.
*Disc is seriously warped. *Use a new disc.
*A “on-standard disc is inserted. .Useo”lydiscswith the @&E mark.
-ym1
*Moisture has formed inside the player. *Wait about 20 to 30 minutes.
Certain sections of a disc are not
*The lock shaft is in the out position (1).
l
Press to the in (unlocked) position (1-m).
played normally.
*Disc is dirty. *Wipe clean with soft cloth.
*Disc is scratched. *Play disc skipping over scratched sections (if
so desired): otherwise replace the disc.
NC search performed when
search dial is turned.
Sound isstrange.
*The dial search button is not on.
*Press the dial search button to “on”.
(Dial search indicator is not illuminated.)
(Dial search indicator illuminates.)
*The pitch control switch is in the “on” position
*Slide the pitch control knob to the center
and the pitch control knob is in a position other position (@D).
than[ID.
Play steps at the beginnng of
each track.
Elapsed playing time is not
shown inthedisptay.
Remote ccntrct commands are
not performed.
Disc is not played normally.
*The auto cue button is on.
(The auto cue indicator is illuminated.)
*Time display mode is set to a different mode.
*No disc is inserted in the holder.
*The remote control unit batteries are weak.
*The remote control unit is being used in a”
improper location.
*The controls were not operated as described
in the instructions.
*Press the auto cue button to cancel this
function.
*Press the correct button for the desired display
mode.
*Insert adisc.
*Replace the batteries.
-Be sure the distance and angle are correct and
that no obstacles are blocking the signal path.
*Switch power OFF and then operate in
accordance to instructions.
t
Maintenance
Maintenance
(Be sureto switch power off before cleaning.)
I
n Wipe the cabinet with a soft, dry cloth.
To avoid harming the cabinet finish. do not clean this unit with
sOlvents or volatile compounds such as alcohol, benzine or paint
thinner. DC not use treated dust cloths or stick tape on the
cabinet as it may lose its gloss or get discolored.
H If the lens is dirty
Adkty lens will cause sound skipping and, if the lens is very dirty,
disc play may not be possible. Open the disc compartment and
Clean the lens as show” in the figure.
Cleaning kit (option) Part “umber: SZZP1038C
*Use a cotton swab to clean away fingerprints, etc. on the lens.
To Next Page
Loading...
Need help?
Power
Audio
Weight and Dimensions
