TechniSat Digit ISIO S2 User Manual

41
Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost.
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key on the device
at the same time.
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for approx.
5 sec. then release.
“Factory setting"
appears in the display.
USB device not recognised USB device formatted for
wrong file system
Format USB device for
FAT32 file format
Device automatically
switches off after a certain
time
Auto Standby function
enabled
Check Auto Standby setting
and disable if necessary.
(see section 7.2.7)

TechniSat Digit ISIO S2 Specifications

General

Signal source	Satellite
Digital signal format system	DVB-S, DVB-S2
Personal Video Recorder (PVR) included	-
Tuner type	Digital
Product color	Silver
Number of tuners	2 tuner(s)
Channels quantity	10000 channels
Audio output channels	- channels
Favorite list TV programs	10000
Digital Satellite Equipment Control (DiSEqC)	1.0, 1.2, Sat-CR
Audio formats supported	FLAC, M4A, MP2, MP3, OGG, WAV
Image formats supported	BMP, GIF, JPG, PNG, TIF
Video formats supported	ASF, AVI, H.264, MKV, MOV, MP4, MPEG1, MPEG2, MPEG4, MPG, TS, TS4, VOB, WMV
Built-in HDD	No
USB 2.0 ports quantity	3
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	13 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	10 - 75 %
Display type	VFD