Name: TechniSat DIGITRADIO 1
Brand: TechniSat
Rating: 5 (1 reviews)

To Next Page

To Previous Page

5.3.4 Using headphones

Damage to hearing!

Do not listen to the radio at high volume with headphones. Doing so can cause

permanent hearing damage. Turn the radio volume down to a low volume before

using headphones.

Only use headphones with a 3.5 mm stereo jack plug.

> Insert the headphone jack into the headphone socket on the side of the

device. Sound is then played exclusively via the headphones and the speaker is

switched to mute.

> If you would like to use the speakers again, unplug the headphones from the

headphone jack on the device.

If you want to set the volume to maximum, the message [Warning! Loud

Volume! OK?] appears shortly before the maximum volume is reached. Confirm

the message by pressing the OK button. You can then adjust the volume to the

maximum possible level. The setting is stored until the device is next switched

off/on.

5.4 General device functions

5.4.1 Switching the device on

> To ensure good DAB+/FM (VHF) reception, please fully remove the aerial located

on the reverse of the device. Please also note Section 5.3.3 when doing so.

> First prepare the DIGITRADIO 1 for operation as described in Sections 5.3.1 and

5.3.2.

> Press the On/Standby button on the top of the device to switch the

DIGITRADIO 1 on.

After switching the device on for the first time, you must set the [language]. To

do so, use the t or u buttons to select one of the available languages and

confirm the selection by pressing the OK button. The device then automatically

runs a full scan in DAB mode. The display information shows the progress

during the scan, plus the number of digital radio stations found. The first DAB+

station is played after the scan has finished.

BDA DigitRadio 1.indd 32-33 16/04/2018 16:41

Other manuals for TechniSat DIGITRADIO 1

Questions and Answers:

Need help?

Do you have a question about the TechniSat DIGITRADIO 1 and is the answer not in the manual?

General