53
DE
EN
NL
FR
PL
When the device is not being used, remove the plug from the socket. Pull the
plug and not on the cable. Remove the plug before a storm starts. Remove
the plug if the device is not going to be used for a prolonged period, e.g.
before going away on a long trip. The heat generated during operation must
be dissipated by adequate air circulation. Therefore the device must not be
covered or installed in a closed cabinet. Ensure there is a free space of at least
10 cm around the device.
4.3.3 Inserting the baeries into the remote control
> Open the baery compartment on the back of the remote control by pushing
it in the direction of the arrow.
> Insert the baeries (2 x AAA 1.5 V) in accordance with the polarity indicated in
the baery compartment.
> Close the baery compartment lid carefully againto ensure that the lid
retaining tabs engage in the housing.
To operate the remote control, you will need an alkaline baery (type Micro,
1.5 V, LR03/AAA). Ensure that the polarity is correct when inserting.
Change a baery that is losing power promptly.
Leaking baeries can cause damage to the remote control.
If the device is not to be used over a prolonged period, remove the baery
from the remote control.
Important information concerning disposal: baeries can contain toxic
substances which harm the environment. Therefore, it is imperative to dispose
of the baeries according to the legal provisions in force. Never dispose of
baeries in normal household waste.
Never place the remote control on extremely hot or very wet surfaces.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
