TechniSat DIGITRADIO 370 CD BT

71
DE
EN
NL
FR
PL
12.2 Alarm
The alarm switches on the DIGITRADIO 370/371 CD BT at the set alarm time. 2 alarm
times can be programmed. The description of how to programme Alarm 1 serves as
an example.
12.2.1 Seing the alarm
> Press the Alarm 1/2 buon (7) on the remote control.
> Use / to select the alarm you want to set and press the ENTER
buon.
> The specific alarm parameters can then be set.
Alarm
> Switch the alarm to [On] or [O].
Frequency (alarm repeat)
> Here you can select from Daily (every day of the week), Once, Weekdays
(Mon - Fri) or Weekends (Sat and Sun). Press ENTER to apply the seing.
Alarm time
> Here you can enter the alarm time and date (if required).
First use the / buons to select the hours and press the ENTER buon to
accept this. Then input the minutes. Again, accept this by pressing the ENTER
buon.
If Repeat> [Once] has been selected, you must also enter the date as well as
the time.
Source
> You then enter the source. BUZZER, Digital radio, FM, CD or USB are
available. Press the ENTER buon to accept the seing.
If you have selected DAB or FM, you can then enter whether or not you
want to be woken up by the last station listened to or by one from your
Favourites list (if favourites have been saved).
Duration
> Then enter the duration. Accept the input by pressing the ENTER buon.
Volume
> You can then set the alarm volume using the / buons. Press the ENTER
buon to confirm.
The time must be read for the alarm to function properly. For more details, see
Section 13.1.2.