TechniSat DIGITRADIO 370 CD BT

60
Stations with a signal intensity below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in section 4.3.1 if required.
6.2.7 Manual seing
This menu item is used to check the reception channels and can be used to align the
antenna. Furthermore, stations can be added manually.
> Press the MENU buon and use the / buons to select the [Scan seings]
> [Set manually] entry, then press the ENTER buon.
> Use the / and ENTER buons to select a channel (5A to 13F). The signal
intensity will now be shown on the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now
be aligned to the maximum signal intensity.
Stations with a signal intensity below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in section 4.3.1 if required.
If there are stations on the set frequency or channel that have not yet been
stored in the station list, they will now also be saved.
6.2.8 Volume adjustment (DRC)
The DRC menu item is used to set the compression rate, which compensates for
dynamic fluctuations and the associated volume variations.
> Press the MENU buon and use the / buons to select the [Sound
Seings] > [DRC] item.
> Press the ENTER buon.
DRC high - High compression
DRC low - Low compression
DRC o - Compression switched o
> Confirm the seing with ENTER.
6.2.9 Deleting inactive stations
This menu item is for removing old stations and those no longer being received from
the station list.
> Press the MENU buon and use the / buons to select the [Scan seings]
> [Remove inactive stations] item.
> Press the ENTER buon.
This is followed by the [Delete] prompt asking if the inactive stations are to be
deleted.
> Use / to select the [Yes] item and confirm by pressing the ENTER buon.