EasyManuals Logo

TechniSat S1 User Manual

TechniSat S1
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
you wish to receive at the DiSEqC setting Position
B/Option A, and confirm by pressing OK. (Fig. 5-8)
Position A/Option B
> Use the arrow up/down keys to mark the satellite
you wish to receive at the DiSEqC setting Position
A/Option B, and confirm by pressing OK. (Fig. 5-9)
Position B/Option B
> Use the arrow up/down keys to mark the satellite
you wish to receive at the DiSEqC setting Position
B/Option B, and confirm by pressing OK. (Fig. 5-10)
As your next step, check again on the configuration of your
antenna.
> If you wish to accept this setting, use the arrow
up/down keys to mark the field Yes, and confirm by
pressing OK. (Fig. 5-11)
Updating software
When you have confirmed the antenna settings, the digital
receiver will automatically check whether a more up-to-date
version of the software for your unit is available via satellite. If
a new version of the software is available, you can perform
an automatic software update.
> Use the right/left arrow keys to select the field
Update, and confirm by pressing OK. (Fig. 5-12)
The new software for your unit will now be downloa-
ded. This procedure may take several minutes.
Scanning for programmes
Once you have checked on the software version, and possi-
bly downloaded an updated version, you can proceed to
searching for programmes.
> Use the up/down arrow keys to mark the field All
Channels, if you wish to scan for both encrypted and
free-to-air programmes, or select All Free-to-air
Channels if you wish to scan for only this type of
programme. (Fig. 5-13)
> Confirm your selection by pressing OK, the unit will
perform an automatic programme search. All the satel-
lites selected during the antenna configuration prove-
dure will be scanned for programmes. This procedure
may take several minutes. Please note any messages
displayed on screen.
When the scan is completed
When the scan has been completed, the number of transpon-
ders found, the number of programmes as well as the num-
ber of new programmes found will be displayed. In addition,
14
(Fig. 5-5)
(Fig. 5-6)
(Fig. 5-2)
(Fig. 5-3)
(Fig. 5-4)
Bed_anl_.qxd 20.02.04 16:28 Seite 14

Table of Contents

Other manuals for TechniSat S1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TechniSat S1 and is the answer not in the manual?

TechniSat S1 Specifications

General IconGeneral
BrandTechniSat
ModelS1
CategoryReceiver
LanguageEnglish

Related product manuals