> Use the arrow keys to mark the programme for
which you wish to view the data.
> Press the Option key to display the data of the trans-
ponder selected (Fig. 7-14).
> Use the coloured function keys to also display
Audio/Video information, Programme information,
and, where appropriate, information on the encryp-
tion system used (CA).
> Press Menu to exit from this display.
7.11 Freeze frame
> Press the Freeze frame key to freeze the current
television picture.
> Press the same key again to revert to normal opera-
tion.
7.12 Video text
7.12.1 Using the video text decoder of your televi-
sion set
Where broadcast, the video text is transmitted to your televi-
sion set. To operate video text functions, use the remote con-
trol of your television set. If you experience problems on your
television set, e.g. an overlay of video text over the picture
content, you should change the setting of your digital receiver
to FBAS mode (Point 6.3.4).
7.12.2 Using the internal video text decoder
Alternatively, you may use the integrated TOP video text
decoder to display the information. The TOP video text
system groups all text pages thematically in groups and
blocks, making use of the function more easy and conve-
nient.
> Switch to the programme on which you wish to view
video text information.
> Display the video text by pressing the Videotext key
(Fig. 7-15).
> Use the numeric keys to enter the desired video text
page. Your selection will be displayed in the upper left-
hand corner of the screen. When you have entered
the desired video text page number, your receiver will
search for this page.
As not all video text pages can be transmitted simulta-
neously, it may take a few seconds for the receiver to
find the page and display it on the screen.
All video text providers use page 100 to show their
index of contents.
> Use the red and green function keys respectively to
page forward or back one page at a time.
27
(Fig. 7-7)
(Fig. 7-8)
(Fig. 7-9)
(Fig. 7-6)
To Next Page
Loading...
Need help?
General