Transponder frequency.
> In this line, use the numeric keys to enter the appro-
priate frequency.
Symbol rate
The symbol rate indicates the volume of data transmitted per
second. A typical figure might be, for example, 27500 (27500
symbols per second).
> Use the up/down arrow keys to mark the line Symbol
rate.
> Use the numeric keys to enter the appropriate sym-
bol rate.
Polarisation
> Use the up/down arrow keys to mark the line
Polarisation.
> In this line, use the OK key to enter the polarisation
plane (horizontal or vertical) on which the desired
programme is broadcast.
Scan mode
> Use the up/down arrow keys to mark the line
Scan mode.
> Use the OK key to decide whether you wish to scan
only for free-to-air programmes (Free
programmes) or whether you wish to include
encrypted programmes (All programmes.
> Confirm by pressing the red function key Start
scan.
The scan will be started. Please note all messages
displayed on screen.
> You can terminate the scan by pressing the red func-
tion key again.
8.4.4 Manual scan
Should a programme not be found by an automatic scan or a
transponder scan, it may be necessary to enter additional,
programme-specific PID numbers for this programme. It may
be necessary to look up these numbers on the Internet, or to
obtain them directly from the appropriate programme provi-
der.
The menu (Fig. 8-18) differs from the menu Transponder
scan only with regard to the menu items PCR-PID, Audio-
PID and Video-PID. There is no need to enter the scan
mode.
> Proceed as described for a transponder scan.
> Then, using the up/down arrow keys, mark the
lines PCR-PID, Audio-PID and Video-PID, and
use the numeric keys to enter the appropriate num-
bers.
8.4.5 After the scan
52
To Next Page
Loading...
Need help?
General