Techno CNC Systems 60120 - Viewer Window Usage

18
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
Viewer
WinCNCcontainsabuiltinviewerwindowthatwillallowyoutodisplaytheoutputofG-Codeles
beforethejobisactuallyrun.Bydefault,theviewercanalsodisplayaG-Codelelinebylineasit
is run.
G0 rapid moves are shown as a black dashed line. G1 feedrate moves are displayed as a solid blue
line.
Toviewalebeforeyourunit,opentheleinthecommandlineandthenpresstheviewerbutton
on the toolbar.
Once the object is loaded into the viewer the following controls can be used:
Zoom In - click the left mouse button.
Zoom Out - click the right mouse button.
Selected Zoom - hold down the left mouse button and drag the box around the area to zoom in
on.
Pan or Re-Center Object - hold CTRL and click either mouse button.
Reset Image - hold shift and click either mouse button
Origin
Where red vertical and
horizontal lines intersect
Current Position
Shows the current
position of the plasma
torch
(Shown as red circle)