47
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 87
G53 Rapid Move - G53 X# Y# Z# W#
Moves to the position specied at rapid velocity, ignoring tool mea-
sures and local coordinates. G53 alone will lift all vertical or type 3
axes.
G54 G54 Workspace - Rotational: G54 X# Y#
Select the Z head. If G54 is commanded from G55, G56, or G57
mode, the Z head will be moved to the current XY position.
G55 G55 Workspace - Rotational: G55 X# Y#
Select the W head. If G55 is commanded from G54, G56, or G57
mode, the W head will be moved to the current XY position.
G56 G56 Workspace - Rotational: G56 X# Y#
Select the U head. If G56 is commanded from G54, G55, or G57
mode, the U head will be moved to the current XY position.
G57 G57 Workspace
Select the V head. If G57 is commanded from G54, G55, or G56
mode, the V head will be moved to the current XY position.
G73 Chip Break Cycle - G73 X# Y# Z# R# Q# F#
Moves to XY specied at Rapid velocity. On the rst peck, moves
to R retract height at Rapid velocity, moves to Q peck depth at F
feed velocity, lifts 0.05” at Rapid velocity to break the chip, moves
to next peck depth at Feed velocity. The cycle repeats until Z
depth is reached. Then moves back to retract height R at Rapid
velocity. Without this cycle, some materials can produce a long
“stringer” which can become a safety issue to the operator.
G80 End Drill Cycle
Used to disable the G81 Drill Cycle mode. Note: Switching to G0
or G1 will also break out of the drill cycle mode.
To Next Page
Loading...
