Techno CNC Systems 60120 - Page 51

51
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 91
L Codes
L1 Save Positions - L1 N# V#
Store values is the saved positions le. Can store a value in one of
the 30 existing ‘H’ registers.
N# is the desired ‘H’ register number, can be 0 to 29.
V# is the desired value. Can be the result of a math operation or a
constant.
L1.1 Save ‘H’ Register
Save the ‘H’ register value to a le.
L1.2 Load ‘H’ Register
Load the ‘H’ register value from a le.
L3 Set Home Position - L3 XYZW
Stores current position of each axis specied. Values specied are
ignored.
L4 Return to Home
Moves each axis specied to the last L3 position stored. Values
specied are ignored.
L5 Set Contouring Velocity - L5 XYZ
Sets the contouring velocity in units per minute.
L6 Set Acceleration - L6 XYZ
Sets the acceleration in units per minute per second. L6 alone
restores the original values.
L7 Set Acceleration Percentage L7 P#
Sets the acceleration to a percentage of the current acceleration.
P# is the percentage (1-100) to set. L7 alone restores the original.
Command Reference