Techno CNC Systems 60120 - Page 59

59
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 99
L112 Test Tool Number - L112 T#.
Skip next line if tool number is equal to T#.
L113 Spindle Speed Conditions - L113 L# H# V#
Skip the next line if the V# is not greater than the L# and less than
the H#.
L120 Tool Change - L120 T#
Sets current tool number for machines with an automatic tool
changer. The tool number is available as {TP2} in subsequent
commands.
L201 Set 201 Signal Command - L201 FileName T# C# S#
Sets the command used with the 201 signal type.
L202 Set 202 Signal Command - L202 [Command]
Sets the command used with the 202 signal type.
L204 Activate Signals
L204 C# activates signals and enables the specied channel.
L204 activates all signals and enables.
L205 Deactivate signals
L205 C# deactivates signals and enables the specied channel.
L205 deactivates all signals and enables.
L210 Select Alternate Low Limits - L210 XYZW
Selects axis to use alternate low limits.
L210.1 Select Alternate Low Limit Pin - L210.1 XYC#
Selects alternate low limit pin from the specied C# channel. If no
channel is specied, the original settings are restored.
Command Reference