Techno CNC Systems 60120 - Page 60

60
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 100
L211 Select Alternate High Limits - L211 XYZW
Selects axis to use alternate high limits.
L211.1 Select Alternate High Limit Pin - L211.1 XYC#
Selects alternate high limit pin from the specied C# channel. If no
channel is specied, the original settings are restored.
L212 Select Primary Limits
Selects the primary limits for all axes.
L213 Dual Axis, Select Main - L213 XYZW
Selects the main motor on a dual motor axis.
L214 Dual Axis, Select Secondary - L214 XYZW
Selects the secondary motor on a dual motor axis.
L215 Dual Axis, Select Both Axes - L215 XYZW
Selects both motors on a dual motor axis.
L249 Laser Power Setting - L249 S# P# D# O# M# I#
Using the L249 command allows you to specify the laser power.
Example: L249 P50 (sets laser power to 50).
S# - 0 or 1 sets smart engrave off/on.
P# - sets the laser pulse width in percentage (1-100).
D# - sets the laser pulse duty cycle (1-100).
O# - sets the bitmap engraving offset.
M# - sets the bitmap engraving margin.
I# - reverses color polarity.
L250 Vector Laser Off
Disables vector laser cutting.
Command Reference