Techno CNC Systems 60120 - Page 70

70
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 112
Error - Illegal Value
The value specied is invalid.
Error - Unknown Position Specied
The position specied is invalid.
Error - Subprogram Nesting Too Deep
Too many nested subprogram calls.
Error - L10 in Subprogram
L10 command found in subprogram.
Error - File Not Found
The specied le name cannot be found.
Error - Parameter Not Specied
A required parameter is not specied.
Error - Unknown
An unknown error has occurred.
Error - Memory Error
Insufcient or bad memory.
Error - User Level 5 Required
A Level 5 user license is required.
Error - Invalid L10 Command
L10 command has invalid parameters.
Error - Invalid P1 Command
P1 command has invalid parameters.
Messages and Error Codes