71
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 113
Error - Command Not Implemented
This command has not yet been fully implemented.
Error - Tool Changer Not Enabled
Tool changer is not set up in the WINCNC.INI le.
Error - Parameter Out of Range
Specied parameter is out of range.
Error - D/A Not Enabled
D/A channel is not set up in the WINCNC.INI le.
Error - Arc Too Small
Specied arc move is too small.
Error - Device Not enabled
The requested device is not enabled.
Error - Could Not Open File
Requested le could be opened. May be in use by another pro-
gram.
Error - Pump Control Not Enabled
The pump control feature has not been enabled.
Error - Soft Limits Not Enabled
Softlimits are set as disabled.
Error - Tangential Knife Not Enabled
The tangential knife feature is not enabled.
Error - Forced Limit Exceeded
Move specied would result in the head being moved outside the
forced limits.
To Next Page
Loading...
