73
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 115
CNC.MAC Not Found
The CNC.MAC le is not found.
Upgrade needed for Key Version 5, or 6 Axis card
And upgrade of the daugtherboard is needed.
Pausing.....
Motion is pausing.
Continuing.....
Motion is continuing.
Finished Running “Filename”
The le “Filename” is complete or has been aborted.
Runtime: #d Minute(s) and #f Second(s)
Run time for the last le in minutes and seconds.
File Not Found
A specied le cannot be found.
Error - Demo Count Exceeded
Demo mode only. 25 commands have been completed.
Error - Helical Interpolation Not Supported
No Z or W moves during an arc.
Escape Button Pushed While Running
User has aborted motion with the ESC key.
Error - Not a BMP File
Tried to open a non-bmp le for bitmap engraving.
To Next Page
Loading...
