74
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
WinCNC Controller
WinCNC Users Guide Page 116
Error - BMP File Invalid Header
Tried to open an incompatible bmp le.
Error - 2-Bit Bitmap Engrave Not Enabled
Tried to open a 2-Bit bitmap without the feature being enabled in
the software.
Error - 8-Bit Bitmap Engrave Not Enabled
Tried to open an 8-bit bitmap without the feature being enabled in
the software.
Error - Vector Laser Not Enabled
Vector laser feature not enabled in the software.
Error - Auto-AuxOut Not Enabled
User has tried to use an Auto-AuxOut without the “autoaux=” line
being set in the WINCNC.INI le.
Error - Depth Must Be Lower Than Retract
Tried to retract a tool to a height that was below current depth.
Error - Unknown
An error has occurred that is undened in WinCNC.
To Next Page
Loading...
