Techno CNC Systems 60120 - Page 83

83
Call: 1-631-648-7481 or Visit: support.technocnc.com
Titan Series WinCNC Manual
WinCNC
Author: Mike Ruff
Becker Pumps Corp.
If light cannot be seen on the inside, the filter is clogged and needs replaced.
Author: Mike Ruff
Becker Pumps Corp.
-If you can see light, then blow out the filter using compressed air and replace-
• This needs to be a
modest amount of light.
• Light should be present
through each pleat.