Operation description: Action:
Dismantling the weight
stack
ONCE THE GUARDS HAVE BEEN REMOVED:
1. Loosen the grub screws of the vibration dampers
(using a 4 mm Allen wrench).
2. Drop the two bars right to the ground and incline them towards
you.
3. Slip o the plates of the weight stack.
Dismantling the pivoting
handle
1. Unscrew the handle pin (using a 5 mm Allen wrench).
2. Remove the handle and its components.
Dismantling the padding
1. Unscrew the rear screws of the padding (using a 6 mm Allen
wrench.)
2. Remove and/or replace the padding.
Dismantling the selection
knob
1. Remove the yellow cap (a) using a small at head screwdriver.
2. Unscrew the screw (using a 4 mm Allen wrench.)
3. Remove the knob.
4. Remove the pin and the spring.
Dismantling roller pads
and bearings
1. Unscrew the screw (using a 5 mm Allen wrench.)
2. Remove the spacers and the roller pad.
PLURIMA - the smart multistation:
Technical Service Guide - Vers. 2.1
Page 30
To Next Page
Loading...
