6. ADJUSTMENTS AND TROUBLESHOOTING...
Description of the problem: Cause: Action:
The weight stack does not slide
uidly
Problem caused by the poor
lubrication of the bars or dirt
that accumulates because of
dust and oil.
Using a paper towel damp with
ethyl alcohol, clean the weight
stack bars of dust and any small
incrustations.
Put the crosspiece back on and
put some drops of oil supplied
in the Box Service on the cross-
piece bushing.
Move the crosspiece up and
down making sure to evenly
distribute the oil along the en-
tire length of the bars.
Dry the excess oil on the bush-
ings with a dry cloth.
WARNING: If the bARs ANd the bUshINGs ARe PARtIcULARLy dIRty, ANd If oNLy the cRossPIece oR jUst oNe PLAte ARe seLected, these MAy
Not Rest PRoPeRLy oN the WeIGht stAck ANd ReMAIN RAIsed by A feW ceNtIMetRes. theRefoRe It WILL be NecessARy to cARefULLy cLeAN ANd
LUbRIcAte the bARs ANd the INNeR PARt of the bUshING.
WARNING: do Not Use too MUch oIL ANd cARefULLy dRy the excess sINce It coULd cAUse dUst to AccUMULAte.
To Next Page
Loading...
