Description of the problem: Cause: Action:
The weight stack cable is not taut
Problem caused by the stretch-
ing of the weight stack cable,
especially during equipment
initial use.
Use the cable tension adjust-
ment system:
Check the tension of the cable
by carrying out some repeated
movements with a minimum
weight and then slowly rest the
crosspiece on the weight stack.
The crosspiece should stay rest-
ing on the weight stack with the
cable slightly strained.
If the cable is new, before adjusting its tension carry out a couple of repeated movements with a maximum
workload to tug and settle the cable.
Adjusting roller play
Problem caused by worn bushing or
bearings.
Use the 2 bushing screws to
adjust the play between the tube
and the extrusion.
Replace the bearings.
Adjusting lever play
Problem caused by the excessive
play of the
bearings.
Replace the bearings.
Adjusting backrest play
Problem caused by the worn
bushings that guide the sliding
extrusion of the backrest.
Move the backrest guide adjust-
ment screw.
The equipment is not level
This problem may be due to the
positioning of the machine on a
surface that is not at.
Use the foot adjustment.
PLURIMA - the smart multistation:
Technical Service Guide - Vers. 2.1
Page 36
To Next Page
Loading...
