Operation description: Action:
Dismantling backrest
adjustment system
1. Unscrew the screws (using a 6 mm Allen wrench), at the rear of
the backrest adjustment extrusion and take it o.
2. Remove the selector cap (using a small at head screw-
driver) and unscrew the screws underneath (using a
4 mm Allen wrench).
3. Unscrew the screws of the end-of-run buers (using a 5 mm
Allen wrench) and remove them.
Operation description: Action:
Dismantling roller top lever
1. Remove the upholstery from its support.
2. Disconnect the steel cable from the lever.
3. Remove the plastic plug.
4. Unscrew the screws (using a 5-6mm Allen wrench).
5. Remove the lever.
Operation description: Action:
Dismantling pin to
change from Leg Curl to
Leg Extension
1. Disassembly the right lever and the left lever.
2. Tilt the upholstery in Leg Curl position.
3. Remove the bush below the upholstery (screwdriver).
4. Unscrew the grubs screws that xing the pin on which the whe-
el upholstery.
5. Remove the two plastic plugs.
6. Remove the screws that secure the pin to the frame.
7. Remove the pin.
8. Pull the knob to select and remove the pin from the frame.
9. Loosen the screw that xing the support in to the plate.
PLURIMA - the smart multistation:
Technical Service Guide - Vers. 2.1
Page 34
To Next Page
Loading...
