Technogym Skillmill - Page 116

4. Ensure that the cable (3) connected to the angle sensor board is inside the cable tie (4).
4
Figure 66
5. Calibrate the brake table.
Remember that, from the SW version SKILLMILL CONNECT: High Kit: BA01.49 - wi-: CA01.16;
SKILLMILL CONSOLE: High Kit: BA01.49, a function has been added at SW level to ensure
a check of the correct calibration. For the details, refer to “6.7 Calibrating the brake table”.
Skillmill
Technical Service Guide - Rev. 3.5
Page 116
email: support@technogym.com