Technogym Skillmill - 6.7 CALIBRATING THE BRAKE TABLE

6.7 CALIBRATING THE BRAKE TABLE
6.7.1 SKILLMILL CONSOLE AND CONNECT CALIBRATION PROCEDURE THAT DOES
NOT ACTIVATE THE BACKLIGHTING OF THE KEYS
• Update the SW with the most recent version (“9. SW update”).

SKILLMILL CONSOLE: High Kit: BA01.49, a function has been added at SW level to
ensure a check of the correct calibration. For the details, refer to “6.7.3 automatic correct
calibration check”.
• Remember to disconnect the MINI USB connector from the console.
• Remember to connect the external power supply to the Connect version of the Skillmill. Ensure that
the Console version of the Skillmill is switched on and fully charged.
• Turn the belt.
• Whenthetimestopsashing,pressandholdkeys1-2-3.Thekeysarenotbacklit.Thefollowing
gureshowsthepositionofkeys1-2-3,whichmustbepressedatthesametime.
1
3
2
Skillmill
Technical Service Guide - Rev. 3.5
Page 88
email: support@technogym.com