Technogym Skillmill - Page 89

 TheleersCALappearonthedisplay.
WARNING: DO NOT ROTATE THE BELT WHILE CALIBRATING THE BRAKE TABLE.
It is forbidden to make the calibration while the treadmill belt is moving because the Skillmill brake
opens during movement, and this will lead to an incorrect calibration.
ATTENTION: Skillmill Console version: the calibration between one level and the next

• Positiontheleveronthelowestbrakingseing(levertowardstherearoftheequipment).
• Presstheheartbuon;theeortlevelindicating“0”willashforafewmomentsandthenchange
to “1”.
• Move the lever forward (one click).
• Presstheheartbuon;theeortlevelindicating“1”willashforafewmomentsandthenchange
to “2”.
• Proceed to level 10.
• Attheendoftheprocedure,ENDwillappearandashforafewmoments.

CONSOLE: High Kit: BA01.49 and subsequent versions: for details about the procedure
to be followed if calibration errors are detected, refer to paragraph “6.7.3.1 what to do if a
calibration error appears”.
Skillmill:
Technical Service Guide - Rev. 3.5
Page89email: support@technogym.com