Technogym Skillmill - Page 92

In detail, what is shown on the display at the end of calibration:
Calibration result Messages on the display
“End” message /
“Err” message
No. of the level
shown on the display
OK End -
NotOKbetweeneortlevel1andeortlevel0 Err 0
NotOKbetweeneortlevel2andeortlevel1 Err 1
NotOKbetweeneortlevel3andeortlevel2 Err 2
...
NotOKbetweeneortlevel10andeortlevel9 Err 9
NotOKbetweeneortlevel10andeortlevel0 Err 10
Example of what appears on the display in the case of a calibration error:
- The error message Err appears;
-Value2indicatesthattherewasacalibrationerrorbetweeneortlevels2and3.
Figure 54
Onlythersterrordetectedisshownonthedisplay,soanyothererrorsmadeduringcalibration
will not be visualised.
Skillmill
Technical Service Guide - Rev. 3.5
Page92
email: support@technogym.com