TECHVIEW QV-3049 - Record; Network Parameters

6.3.3.2 Record
Click <Record> option to unfold its sub
6.3.3.3 Network Parameters
Unfold <Network> option to enter into its sub
configuration.
1、Network
2、Sub stream
(shown as Picture 6
Picture 6-15
Picture 6
-
17
Picture 6-18
Picture 6-19
29
Click <Record> option to unfold its sub
-
options: Record parameter, Schedule and Main stream.
Unfold <Network> option to enter into its sub
-
options: Network, sub stream, E
(shown as Picture 6
-
21): Relative parameters should be consistent with DVR local setting.
1、
Record Parameters:
option, allow
you set channel, record enable, pack time
and Pre-
record status shown as Picture 6
2、 Schedule:
Detailed parameters please refer to DVR
local setting (shown as Picture 6
Green stand for Normal record; Yellow stands for
Motion detection;.
3、 Main Stream:
detailed settings please refer to DVR
local setting (shown as Picture 6
modifies the resolution, frame rate, Bit rate and audio
of the record channel.
1、 The model support
three network type, including
Static, DHCP and PPPoE. System default <Static> as
its network type. User could allocate IP and perform
Port forwarding for DVR according to different router.
When set <UPNP> to “On”, user no needs to perform
port forwarding.
Once you modify the network
parameters successfully, DVR will automatically
restart.DVR
For details parameters please refer to below Picture
6-18, Picture 6-
19 and Picture 6
Picture 6
Picture 6
User Manual
options: Record parameter, Schedule and Main stream.
options: Network, sub stream, E
mail, mobile and DDNS
21): Relative parameters should be consistent with DVR local setting.
Record Parameters:
Under [Record parameters]
you set channel, record enable, pack time
record status shown as Picture 6
-15;
Detailed parameters please refer to DVR
local setting (shown as Picture 6
-16).
Green stand for Normal record; Yellow stands for
detailed settings please refer to DVR
local setting (shown as Picture 6
-16). Herein allow user
modifies the resolution, frame rate, Bit rate and audio
three network type, including
Static, DHCP and PPPoE. System default <Static> as
its network type. User could allocate IP and perform
Port forwarding for DVR according to different router.
When set <UPNP> to “On”, user no needs to perform
Once you modify the network
parameters successfully, DVR will automatically
For details parameters please refer to below Picture
19 and Picture 6
-20.
Picture 6
-16
Picture 6
-20