27 / 52
In any case if a sequence process error is made, it is possible to repeat the last weld or another weld,
or continue by avoiding some spots. Always with the key in RUN position, use keys a to increase the
welds counter to the next spot or to the desired spot. Use key s to go back one or more positions of
the spots to be carried out.
WELD 006 OF 013
STEP 02 OF 04
PROG. 07 RMS 06.15
NEXT WELD 007
WELD 013 OF 013
STEP 04 OF 04
PROG. 04 RMS 04.31
NEXT WELD 001
WELD 007 OF 013
STEP 03 OF 04
PROG. 11 RMS 06.15
NEXT WELD 008
WELD 012 OF 013
STEP 03 OF 04
PROG. 11 RMS 04.31
NEXT WELD 013
Display data Display data after key
To Next Page
Loading...