28 / 52
All the inputs available at the connectors of the control unit are included in the list that is scrolled with
keys d and f
. The status of the inputs is shown as active (Input closed with COM1) with wording ON;
not active with wording OFF.
CHECK INPUT MENU
This menu displays the status of the welding control unit inputs. It is activated with the key in PROG
position and is used for checking the efficiency and proper operation of the external devices, connected
to the control unit, required for using the welder.
-- CHECK INPUT --
> START N.O. OFF
START N.O. ON
START2 N.O. OFF
To Next Page
Loading...