24 / 52
N. STEPS
The value of this parameter indicates the number of steps, i.e. the number of spot sequences with
different work programs.
STEP PROG. 1,2,3,...
This program indicates the program number that the welder must carry out and is matched to the
associated step number.
WELDS STEP 1,2,3,...
The value of this parameter indicates the number of welds to be carried out with the program matched
to the same step.
After having activated this mode and having set the parameters of the "Program sequences" menu as
described above, the welding spots can be started. With the key in RUN position, the display shows the
sequence data as shown in the figure below.
PROG SEQUENCE
Program sequence activation
ON
PARAMETER DESCRIPTION VALUE RANGE
NUMBER SEQUENCES Number of sequences 01 - 05
STEP 1 PRG. Program of step 1 01 - 63
STEP 1 WELDS Number of welds with step 2 00 - 20
STEP 2 PRG. Program of step 2 01 - 63
STEP 2 WELDS Number of welds with step 1 00 - 20
STEP 3 PRG. Program of step 3 01 - 63
STEP 3 WELDS Number of welds with step 3 00 - 20
STEP 4 PRG. Program of step 4 01 - 63
STEP 4 WELDS Number of welds with step 4 00 - 20
STEP 5 PRG. Program of step 5 01 - 63
STEP 5 WELDS Number of welds with step 5 00 - 20
This menu includes the parameters required for activating the program sequence operations. In this
work mode the weld control unit commands the welder to perform a series of spots, deciding
automatically the work program for each spot and the spots order without having to make an external
selection of the program.
This menu is not always active in the main programming menu. It is activated by setting the parameter
of the Setup to ON.
PROGRAM SEQUENCE MENU
PROGRAM SEQUENCE MENU PARAMETERS TABLE
When this menu is activated it can be accessed with key g and the parameters shown in the figure can
be set.
- PROGRAM SEQUENCES-
> NUM. STEPS 02
PROG. STEP 1 03
WELD STEP 1 07
To Next Page
Loading...