Page 4

TECNA TE 500 - Page 4

52 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

4 / 52

This page is intentionally left blank.

Table of Contents

Table of Contents3
Te500 Welding Control Unit5
Main Features5
Control Unit Switch-On6
Control Unit Programming7
Description of the Parameters9
Configuration Menu13
Stepper Menu15
Current Stepper Operating Mode16
Installation Menu21
Program Copy Menu23
Program Sequence Menu24
Program Sequence Example26
Check Input Menu28
PANEL Leds29
Commands on the Panel30
Self-Calibration Procedure31
Selection of the Work Program32
Work Modes33
Constant Current Operating Mode34
Description of the Work Cycle35
Measurement of the Welding Current and the Conduction Angle36
Welding Analysis37
Welding Current and Conduction Angle Limits38
Compensation of the Secondary Current39
Welding Spots Counter Function39
SERIAL INTERFACE RS-232 ITEM 50214 (Option)40
SERIAL INTERFACE RS-485 ITEM 50209 (Option)42
INTERFACE for PROPORTIONAL VALVE ITEM 50220 (Option)43
Interfacing with Automatic Systems44
Double Stroke Function45
Description of Signals on Terminal Board46
Messages List48
First Insertion Delay Adjustment51

EasyManua.ls – Your Ultimate Manuals Destination!

With a comprehensive collection of over 1 million PDF manuals, service guides, instruction booklets, and quick start guides, we cover every aspect of your needs. Explore manuals for products from more than 50,000 brands all in one place. Search and instantly view the manual you’re looking online for free.

Privacy Policy
Contact Us

© Copyright 2026 EasyManua.ls. All Rights Reserved.