TECO N3 Series - Page 32

N3 Drive Operations Manual
b (Basic) & A (Advanced) Parameters defined; b004 – b016 29
Parameter
No.
LCD Display
Description
Range/Code
Factory
Setting
Remarks
b004
Frequency
Source
Frequency
Command Source
Selection
0000: Keypad
0001: Potentiometer on Keypad
0002: External Analog Signal Input
or Remote Potentiometer
0003: Up/Down Frequency Control
Using MFIT (S1 - S6)
0004: Communication setting
frequency
0005: Pulse Follower
0000
b005
Freq Upper
Limit
Frequency Upper
Limit (Hz)
0.01 - 400.00
50.00／
60.00
2
b006
Freq Lower
Limit
Frequency Lower
Limit (Hz)
0.00 - 400.00
0.00
b007
Accel Time 1
Acceleration Time
# 1 (Seconds)
0.1 – 3600.0
10.0
1
b008
Decel Time 1
Deceleration Time
# 1 (Seconds)
0.1 – 3600.0
10.0
1
b009
V/F Selection
Volts/Hz
Patterns(Password
protected
0 - 18
9
2 & 3
b010
Password
Parameter
Lock(except B010)
0000: Disable
0001: Enable
0000
b011
Advanced
Display
Advanced Display
0000: Disable
0001: Enable
0000
b012
Select
Language
Language
Selection
0000: English
0001: German
0002: French
0003: Italian
0004: Spanish
0000
Only for
LCD
Keypad
(option)
b013
Mtr Current
Motor Current
Display Selection
0000: Disable Motor Current
Display
0001: Enable Motor Current Display
0000
1
b014
Mtr Voltage
Motor Voltage
Display Selection
0000: Disable Motor Voltage
Display
0001: Enable Motor Voltage Display
0000
1
b015
Bus Voltage
DC Bus Voltage
Display Selection
0000: Disable Bus Voltage Display
0001: Enable Bus Voltage Display
0000
1
b016
PID
Fdbk(S6)Disp
PID Feedback
Display Selection
0000: Disable PID Feedback
Display
0001: Enable PID Feedback
Display
0000
1
Notes:
1 - Can be modified during run.
2 - Related to factory settings in North America or overseas
3 - Only available in V/F mode. Please refer to Fig. 19.27 for V/F Patterns.
Factory Setting 9 is for 60Hz General Use Application.
Cont.