Chapter 10 Test Run 125
Chapter 10 Test Run
10-1 Confirmation before Test Run
Confirmation ＊The control panel is vertically
before installation installed properly.
＊Each module is fasten in fixed place.
＊Properly wiring
＊Terminal Block is well locked by screw.
Confirmation on power ＊Cable complies with specified requirement.
cable, I/O cable and ＊Power cable is wrapped?
Signal cable ＊Check if the I/O cable is routed parallel
or close to high voltage and current cable.
＊Check the output cable is protected by fuse.
＊Signal cable is shielded twisted wires?
Power Supply Confirmation ＊The voltage of power supply is as specified.
End of Test Run
To Next Page
Loading...
