6-5
Note：
※ The setting value of the counter could be a constant or the present value of the timer,
counter，analog input A1~A8.
※Foer I1~gF, Input terminal: I1~IC (I1~I12), Output terminal: Q1~Q8, Expansion Input
Terminal: X1~XC (X1~X12), Expansion Output Terminal: Y1~YF (Y1~Y12), Counter: C1~CF
(C1~C15), Timer: T1~TF (T1~T15), RTC Comparator: R1~RF (R1~R15) , Analog Comparator:
G1~GF (G1~G15),Auxiliary Terminal:M1~MF（M1~M15）.
The upper case (I1) is Contact ‘a’ while the lower (i1) case is Contact ‘b’.
※ The set value of counter can be modified via communication module as MODBUS,
PROFIBUS, DEVICENET, TCP/IP.
(1) Counter Mode 1
Note：
※ When Run user program, current value shall be initialized to be 0 or preset value.(If up
counter, then 0; if down counter, then preset value)
To Next Page
Loading...
