6-38
Note:
(1) When the Display is enabled, the user can press the SEL button for 3 seconds to show the HMI
(Text) Messages.
(2) This HMI option is for Timer/Counter/Analog/Coil Status display only. When the option is enabled,
it will show A1=#.##V, otherwise, it will display #A1#.
(3) Select Coil Status I, M, X. When the Unit is enabled, it will show I2=###, otherwise, it will display
#I2. (### = ON/OFF)
(4) Analog Comparator Display Set: To set Gain (1~999) and Offset(-50~+50) value.
(5) First Line can set Phone Number.
◎ The following example covers to modify the preset value of C1 in HMI under
run mode：
To Next Page
Loading...
