TECO SG2 - Page 92

6-54
2. Qx ⇒ space ⇒ Qx (only for digital and character position of 8 column.).
3. ┬⇒ space ⇒ ┬ (all available but the 2,4,6 column of the first line)
┴ ┴
x : Digital: 1~F
SEL +↑/ ↓
1. 1...F, ─ (When the cursor locates the digital position, the range of digital is restricted by the
relay type.
2. I ⇔ X ⇔ Q ⇔ Y⇔ M ⇔ D ⇔ T ⇔ C ⇔ R ⇔ G ⇔ I
(When the cursor located at 1,3,5 Column).
3. Q ⇔ Y ⇔ M ⇔ T ⇔ C ⇔ R ⇔ G ⇔H ⇔ L ⇔P ⇔ Q
(When the cursor located at 8 Column)
4. ( ⇔ ¿ ⇔ À ⇔ P ⇔ ( (When the cursor located at 7 Column, and the 8 Column is set as
Q,Y,M)
5. ( ⇔ P ⇔ ( ((When the cursor located at 7 Column, and the 8 Column is set as T)
SEL + ←/→
Confirm the input data and move the cursor
↑/ ↓
Vertically move the cursor
←/ →
Horizontally move the cursor
DEL Delete an instruction
ESC 1. Cancel the Instruction or action under Edition.
2. Back to Main Menu after query the program.
OK 1. Confirm the data and automatically save, the cursor moves to next input position.
2. When the cursor is on Column 8, Press the button to automatically enter the function block
and set the parameters(such as T/C)。
SEL+DEL Delete a Line of Instruction.
SEL+ESC Display the number of the Lines and operation state of SG2 (RUN/STOP)。
SEL+↑/ ↓
Skip up/ down every 4-line program.
SEL+OK Insert a space line
Operation Sample：
12345678Column
Line 1 >LADDER
2FUN.BLOCK
3RUN
4CLEAR PROG.
Procedure 1: 1 2 3 4 5 6 7 8 Column
Press ‘OK’ Line 1
2
Enter LADDER Edition 3
4