Chapter 3: Menu reference > Option 15 Time & Date
Challenger10 Administrators Manual 39
1-First Sunday, Month 00
Start Month:
Enter a value in the range 1 to 12 and press [ENTER] to indicate which month
daylight savings time begins. The following example shows the LCD screen
where a value of 10 is entered.
1-First Sunday, Month 10
Start Month:
If correct press [ENTER] to accept, and then to program the end Sunday.
0-Disable, Month 00
End Sunday:
Enter a value in the range 1 to 5 and press [ENTER] to indicate which Sunday in
the month daylight savings time ends. The following example shows the LCD
screen where a value of 1 is entered.
1-First Sunday, Month 00
End Sunday:
If correct press [ENTER] to accept, and then to program the end month.
1-First Sunday, Month 00
End Month:
Enter a value in the range 1 to 12 and press [ENTER] to indicate which month
daylight savings time ends. The following example shows the LCD screen where
a value of 4 is entered.
1-First Sunday, Month 04
End Month:
If correct press [ENTER] to accept.
Correct
From the Time & Date menu, press [4] [ENTER] to program a time correction for
the Challenger panel’s internal clock (if needed).
Seconds Correction Per Day: +0
*-Chg, Sec:
Enter the value in seconds, press [MENU*] to toggle the + or – factor, for the
amount of seconds you need to add or subtract each day, and then press
[ENTER].
To Next Page
Loading...
