Tektronix 314 - Page 59

Performance CheckICalibration-314 Service
TABLE 5-1 (cont)
Description
Minimum Specifications
Usage
Dual-Input Cable
-or-
T-connector and 2
short Cables
Connectors, BNC.
Connectors, BNC.
To connect signal to two
inputs simultaneously.
To connect signal to two
inputs simultaneously.
Check and adjust input
capacitance.
Reduce signal level while
maintaining system
impedance.
Normalizer
Attenuator,
Feedthroug h
Attenuator,
Feedthrough
For 47
pF Input;
Connectors, BNC.
Attenuation, 10X; impedance,
50 n; connectors, BNC.
Attenuation, 2X; impedance,
50 n; connectors, BNC.
Adapter
Reduce signal level while
maintaining system
impedance.
To adapt Constant Ampli-
tude Signal and Square-
Wave Generator outputs to
BNC.
Check external blanking.
GR to BNC female.
Patch Cord
Patch Cord
BNC to banana.
Pin jack to BNC male. Check calibrator output.
- - - -
Adjust vertical amplifier
balance.
Adjust external atten-
uator compensation.
Test
Oscilloscope' (with
included
10X
probe)
Adjust variable resistors.
Bandwidth, dc to 10 MHz;
minimum deflection factor,
1
mV/Div; accuracy, with-
in 3%.
Screwdriver1
I LOW capacitance. I
Calibration
Shield1
Plug-in Extension
Cable1
Adjust variable capacitors.
Adjusting attenuator
compensation.
For extending time-base
storage module.
Examples of Applicable
Test Equipment
Tektronix Calibration
Fixture, 067-0525-00.
T-connector, Tektronix
part number 103-0030-00.
Cables, 18-inch, Tektronix
part number, 012-0076-00.
Tektronix Calibration
Fixture, 067-0541-00.
Tektronix part number,
01 1-0059-02.
Tektronix part number,
01 1-0069-02.
Tektronix part number,
01 7-0063-00.
Tektronix part number,
01 2-0090-00.
Tektronix part number,
175-1 178-00.
-- -- --
Tektronix 465 or any
general purpose
oscilloscope meeting
minimum specifications.
a. Excelite R3323.
a. Tektronix part number,
003-0000-00.
Tektronix part number,
067-0750-00.
Tektronix part number,
067-0742-00.
'use with Adjustment procedure only.
'use with TM
500 Series Power Module.
REV. B, AUG. 1977