Index
Index-2
370B User Manual
default settings, 3–4
Default Setup Controls
ACQ MODE, 3–4
MAG, 3–4
MEMORY INDEX, 3–4
AUX SUPPLY, 3–4
COLLECTOR SUPPLY, 3–4
CONFIGURATION, 3–4
CURSOR, 3–4
Display, 3–4
GPIB, 3–4
LEFT–RIGHT–STANDBY, 3–4
Measurement, 3–4
POSITION, 3–4
STEP GENERATOR, 3–4
device dependent messages, 4–8
device–dependant message format, 4–22
Digital Storage and Mass Storage System, 3–39
Digital storage capability, 1–1
directory display, 3–43
Display Controls, CURSOR SELECTION, 2–13
Display controls
ENTER, 2–10
HORIZONTAL, 2–11
INVERT, 2–12
NON STORE/CAL ZERO, 2–8
REF/CALL FULL, 2–9
STORE/CAL OFF, 2–8
VERTICAL control, 2–11
VIEW, 2–9
display data and CRT readout I/O commands and
queries, 4–30
Display Offset and Magnifier, 3–12
DISPLAY control, 2–14
E
editing text, 3–46
enable/disable
AUX supply , 2–25
collector supply, 2–25
step generator, 2–25
ENTER, Display Controls, 2–10
Envelope , 1–2
erasing the nonvolatile IC Memory, 3–27
event codes, 4–46
extended acquisition modes, 1–2
F
factory default values, 3–4
FAST/SHIFT, 2–22
FAST/SHIFT button, 2–23
Field Effect Transistor, 3–54
firmware upgrade, 3–47
first time operation, 3–3
fLINE, CURSOR SELECTION, 2–13
floppy disk drive, 3–25
floppy disk, handling, 3–42
FOCUS, 2–3
Focus, 3–28
formatting a disk, 3–43
Front panel
Aux Supply, GPIB, FAST/SHIFT, and Floppy Disk
Drive controls, 2–22
Cursor and Position controls, 2–13
display controls, 2–8
Instrument Power and CRT controls, 2–2
Measurement, ACQ Mode, and Mag controls, 2–4,
2–19
Memory Index and Setup controls, 2–6
Signal Input and Output Controls, Connectors,
Configurations and Indicators, 2–25
Step Generator controls, 2–16
front panel controls, 4–28
front panel controls, 2–1
front panel terminal, 3–38
Fuse, 1–3
G
general description of instrument operation, 3–2
GPIB commands, 4–28
GPIB control, 2–22
GPIB diagnostic routine, C–5
GPIB hardware, 4–2
GPIB service requests, 4–43
GPIB TERMINATOR and ADDRESS switch, 2–27
GRAT ILLUM, 2–3, 2–28
H
handling a floppy disk, 3–42
Hardcopy and Save the CRT Image, Hardcopy, 3–41
hardcopy and save the CRT image
BMP file, 3–41
hardcopy, 3–41
HARDCOPY control, 2–23
Horizontal Measurement and Deflection Factor, 3–30
HORIZONTAL, Display Controls, 2–11
To Next Page
Loading...