Index
370B User Manual
Index-3
I
IEEE STD 488 PORT, 2–27
IEEE488 Standard Bus Interface Connector, 2–27
Initial Inspection, 1–2
inspection and cleaning, D–1
Installation, 1–2
instrument operation, 3–2
Instrument Power and CRT controls, 2–2
FOCUS, 2–3
GRAT ILLUM, 2–3
GROUND, 2–2
INTENSITY, 2–2
POSITION, 2–3
POWER, 2–2
TRACE ROTATION, 2–3
instrument setup over the bus, 4–15
INTENSITY, CRT, 2–2
Intensity, 3–28
interface messages, 4–6
Interlock System, 3–35
INVERT, Display Controls, 2–12
K
Kelvin Sense, 1–7
Kelvin Sensing Connections, 1–7
L
LIMITER, Collector Supply controls, 2–21
LINE FUSE Holder, 2–27
Line Fuse verification, 1–3
loading data from the controller, 4–20
LOCAL, control, 2–22
LOOPING COMPENSATION control, 2–21
M
MAG X10, 2–5
masking service requests, 4–44
mass storage, 3–40
MAX PEAK POWER WATTS, COLLECTOR
SUPPLY CONTROLS, 2–20
MAX PEAK VOLTS, COLLECTOR SUPPLY
CONTROLS, 2–20
Measurement Modes
Repeat, 3–31
Single, 3–31
Sweep, 3–31
Measurement, ACQ, Mode, and MAG controls
ACQ MODE, 2–5
MAG X10, 2–5
REPEAT, 2–4
SINGLE, 2–4
SWEEP, 2–4
measurements, 3–31
measuring examples, 3–49
memory index number (Setup ID), 2–29
messages, C–6
moving waveform data to the controller, 4–18
N
NOMINAL , operating voltage, 1–3
Non Store Mode, 3–45
NON STORE/CAL ZERO, Display Controls, 2–8
NUMBER OF STEPS, Step Generator Controls, 2–17
O
OFFSET AID and OPPOSE
AID, 2–17
OPPOSE, 2–17
OFFSET AID AND OPPOSE, Step Generator Controls,
2–17
operating clearance , 1–5
operating temperature, 1–5
operating the instrument, 3–2
Operating Voltage, 1–3
operating voltage
NOMINAL, 1–3
RANGE, 1–3
optional accessories, B–2
options and accessories, B–1
Output Mode Selections
CURRENT, 2–17
VOLTAGE, 2–17
Output Mode Selections, Step Generator Controls, 2–17
Outputs, enable/disable, 2–25
P
performance conditions, A–1
Phone number, Tektronix, 4
polarities of the Collector Supply and Step Generator
Output, 3–39
POLARITY
+DC and –DC, 2–20
+LEAKAGE AND–LEAKAGE, 2–20
To Next Page
Loading...