Commands Listed in Alphabetical Order
Syntax
HORizontal:DI
STance:DIELectric <NR3>
HORizontal:DISTance:DIELe ctric?
Related Commands
HORizontal:UNIts, HORizontal:DISTance:PVELocity
Arguments
NR3 is the dielectric constant of the material being tested.
HORizontal:DISTance:PVELocity
This command sets or queries the Propagation Velocity. This is equivalent to
setting the Propagation Velocity in the Distance section of the Horizontal Setup
dialog box.
Group
Horizontal
Syntax
HORizontal:DISTance:PVELo city <NR3>
HORizontal:DISTance:PVELo city?
Related Commands
HORizontal:UNIts, HORizontal:DISTance:DIELectric
Arguments
NR3 is the propagation velocity of the material being tested.
HORizontal:EXT10MHZref:FREQ
This command sets or queries the e xternal 10 MHz reference frequency. The
command allows you to adjust the external 10 MHz reference frequency to ensure
that the timebase locks when the Lock to Ext. 10 MHz mode is set using the
HORizontal:TBMode c ommand.
Group
Horizontal
Syntax
HORizontal:EXT10MHZref:FR EQ <NR3>
HORizontal:EXT10MHZref:FR EQ?
Related Commands
HORizontal:TBMode
2-160 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
