Commands Listed in Alphabetical Order
MASK<x>:COUNt
?, HIStogram:STATistics? , HIStogram:STATistics:MEAN?,
HIStogram:STATistics:MEDIAN?, HIStogram:STATistics:STDdev?,
HIStogram:STATistics:PKTOPK?, HIStogram:STATistics:SIGMA<x>?,
HIStogram:STATistics:PEAKHits?, HIStogram:STATistics:HITS?,
HIStogram:STATistics:WAVeforms?
Arguments
NR1 is the desired timeout duration specified in seconds. When any of the related
commands are issued to the instrument, if query results are not produced before
the timeout expires, a timeout condition will occur. Typically, this will result in
error eve
nt being posted to the Event Queue and will be reflected in the Standard
Event Status Register (SESR). For a more detailed discussion of error reporting,
please refer to the Status and Events section.
Examples
SYNC:TIMEOUT 10 adjusts the synchronization timeout to a duration of
10 seconds.
SYNC:TIMEOUT? might return 3, indicating the default timeout is 3 seconds.
SYSTem:PROPerties:ACQHWver? (Query Only)
This query only command returns the hardware version of the Acquisition circuit
board in the instrument.
Group
System
Syntax
SYSTem:PROPerties:ACQHWver ?
Examples
SYSTEM:PROPERTIES:ACQHWVER ? might return
SYSTEM:PROPERTIES:ACQHWVER 1.
SYSTem:PROPerties:CH<x>:BANDwidth? (Query Only)
This query only command returns a li
st of available bandwidth selections or, if
applicable to the sampling m odule channel, its characteristic bandwidth.
Group
System
Syntax
SYSTem:PROPerties:CH<x>:BA NDwidth?
Related Commands
CH<x>:BANdwidth:LIST?, CH<x>:BANdwidth:VALue
DSA/CSA/TDS8X00/B Series Programmer Manual 2-281
To Next Page
Loading...
